1. Fixing of trough aluminum: before fixing trough aluminum, the wire must be positioned first, and the deviation cannot exceed 5mm. The trough aluminum is fixed with M5x30 cored aluminum pull studs, and the indirection does not exceed 300mm. Double pull studs must be set at the door opening, and the interval does not exceed 50mm. .
2. T-shaped hanging beam is fixed: the hanging code is positioned along the position of the line, and the spacing does not exceed 1.20m. When the T-shaped beam and the connecting color steel plate are fixed, they must be compressed with angle aluminum or angle iron, and no gaps must be left. Above the joint of two color steel plates.
3. Tuyere installation: The installation of the tuyere on the ceiling should be constructed according to the drawings, avoiding T-beams. The exhaust and return air outlets on the wall should be installed 200mm above the ground.
4. Appearance requirements: The overall installation needs to be straight and beautiful, and there must be no collision or scratch marks. The protective film can be torn after the board seam connection is flat, the board gap spacing is 3-4mm, and the glue should be full and straight without gaps. .
5. There must be 3 self-drilling screws for fixing between each top plate and the enclosure plate, and the connection between the enclosure plate and the vertical plate shall be fixed with a pull stud at the top and bottom. The joints must be vertical during construction.
6. Door and window installation: The installation position and opening direction of doors and windows are determined according to the requirements of the drawings. The single-open door should be on the same color steel plate as much as possible, and the line of the double-open door should be at the joint of the plate seam as much as possible, so that the cut color steel plate can be used as the door panel. The profile connection needs to be tight, there should be no gaps, and the overall door knob retention size must be unified.
7. The inner and outer arcs are fixed: the connection with the color steel plate must be tight, the outer arc column is not connected, the inner arc connection points are in a good position, and the gap is tight.
